Deutsch
Francais
Nederlands
Make your own leather bracelet for sliding beads
In this DIY tutorial we show them how to make leather bracelet for sliding beads themselves.
Make individual leather bracelets yourself. We show you here how to make bracelets of any length you want with our template.
With the help of our template you can easily make a leather bracelet in the individually desired size yourself.
First you need to cut out the two templates. If you want to use the templates often, you can also glue them additionally on sturdy cardboard.
First you need to cut out the two templates. If you want to use the templates often, you can also glue them additionally on sturdy cardboard.
The leather strap is pre-cut to the correct width. Determine your desired bracelet length. For a wrap bracelet, 40 cm is a good length. Put on the template and draw the markings with a wipe-proof pen.
Repeat this with the second part of the template on the front part of the tape. You can decide for yourself whether and how many additional holes you want to draw for adjusting the tape.
Cut the tape at the markings with a cutter or scissors. Then punch the desired number of holes in the tape. The holes should have a diameter of at least 3.5 mm.
To make the bracelet easier to open and close, you can also add a small bleed to the holes on one side of the bracelet with the cutter.
The screw plug is now attached to the other side of the bracelet. In addition, you can also pull a loop on the bracelet. This closes the bracelet securely.
