Thread ring

In this DIY tutorial we show them how to thread a ring.

Cut an approx. 30 cm long piece of thread from the Illusion Cord roll. Thread the cord through the two adjacent threading holes of the cauldron. Pull one Swarovski Crystal Pearl each onto the thread on the right and left.
Thread a third Crystal Pearl and cross the two threads in the bead.
Work a total of 29 Crystal Pearls into a ring bar.
Close the ring rail by threading the thread through each of the threading holes in the ring rail and knotting it in the kettle.
To make the ring rail more stable, first thread one end of the thread back through the thread hole onto the outside of the cup.
Then start threading the thread back through the top row of Crystal Pearls bead by bead.
Repeat this also for the lower row of Crystal Pearls. Knot the two ends of the thread again on the inside of the cauldron and cut off the excess thread. Finally, place the Swarovski stone in the cauldron and bend the claws as shown in the basic instructions. How to set a Swarovski stone in the claw donkey, we explain here: Setting Rivoli and Chatons with a Claw Cauldron