Floral earrings with modeling wire

... here you will find all instructions with material lists - all items with one click into the shopping cart

Floral earrings with modeling wire
For the earrings you need round Galas Sweet and Swarovski beads, Craft Wire with 0.4 mm diameter and ear hooks.
Cut yourself a piece of silver wire about 20 cm long with the side cutter. To bend an eyelet for the flower pendant use a pair of rosary pliers. These pliers have round jaws and are therefore very suitable for bending a round eyelet. Place the wire approximately in the middle on one jaw of the rosary pliers.
Wrap the wire around the pliers several times and twist both wire ends tightly to the pliers. Now you can remove the eyelet from the pliers.
String five Gala Sweet beads on one side of the wire.
Bend the wire into a circle and wrap the end of the wire onto which the beads were strung tightly around the eyelet twice.
To give the flower stability later, pull the wire end back through the first Gala Sweet bead to the left of the eyelet.
Firmly pull the entire end of the wire through the first bead. And let the rest of the wire hang freely for the time being.
Now thread the Swarovski ball onto the other end of the wire.
Bend the wire forward so that the Swarovski ball is in the center of the bead circle.
Now bend the wire between the second and third Gala Sweet bead to the back of the flower and turn the flower over. On the back of the flower, the wire is led back up to the eyelet.
Now wrap the wire around the bottom end of the eyelet again several times.
Pull the wire back through the first Gala Sweet bead to the right of the eyelet.
Cut off the two protruding wire ends with the side cutter.
Make a second flower using the same pattern.
Hook the eye of the flower into the bent up eye of a fishing hook and bend the eye of the ear hook closed again.
The Gala Sweet flower earrings are ready.